The test thorn probe is intended to verify the protection against access to glowing heating elements. It complies with IEC61032 figure 16 Test probe 41, IEC60335 standard requirements.
The test hook complies with IEC60065. It is used to test whether the dangerous electric parts can be touched. The test hook is “hooked” into vents and seams in the enclosure & then pulled with a force (usually 20N). The hook has a hole at its long end, for use in conjunction with a PFI series Force Gauge. It is made entirely of stainless steel.
We know your desire for precision and reliability, so the HT-I28 Test Finger Probe was born. It is not just a tool, but also your trusted partner in the field of electrical safety. Whether it is the door interlock device detection of the microwave oven, or the anti-electric shock, shell protection and other tests, it can bring you a safe testing experience with accurate parameters and stable performance.
The test pin is used to do the scratch resistant test of the electrical solid insulation surface. It conforms to the standard requirement of IEC60335-1 clause 21.
The test rod probe confirms to IEC61032 figure 15 requirements. It is intended to verify the protection provided by fan guards against access to hazardous mechanical parts. It is equipped with nylon handle.Customizable: It is used for enclosure protection test when open threaded hole of M6 at the end of the handle (connected with pull and push dynamometer).
This test sphere probe confirms to IEC61032 figure 5 test probe 1,IEC60335,IEC60950, IEC60598,UL507 standards. It is intended to verify the degree of protection of enclosures against ingress of solid foreign objects having a diameter of 50mm or greater. It is also regarded as the steel ball for dropping impact test. It can be equipped with a lifting ring, and used for pendulum bob test after hanging with a rope. Steel balls with other diameters can be customized.
